Furman M-8Dx Power Conditioner
A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-8Dx into the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. The M-8Dx features two slide out, swiveling light fixtures to provide discreet illumination of your equipment on stages, in studios, and in other dark places. A dimmer knob lets you adjust the lamp brightness to just the right level.The M-8Dx also features a bright red, three-digit LED voltmeter that displays incoming voltage.
Noise Filtration: AC noise filtering to reduce radio frequency and electromagnetic interference (RFI/EMI)
Surge Protection: Spike & surge protection ensures equipment stays safe and your power stays clean
9 Total Outlets: 8 rear panel outlets and 1 front panel convenience outlet
Digital Voltmeter: Digital voltmeter display incoming line voltage
15 Amp Rating: 15 amp rating, with circuit breaker
"Protection OK" Indicator: Front panel indicator LED lets you know that your equipment is being protected
Wall Wart Spacing Indicator: Rear outlets have been spaced to accomodate even the bulkiest of wall warts and adapters
Front Panel Pull-out Lights: Two retractable incandescent light fixtures with dimmer control for convenient rack illumination
Maximum Output Current: 15 amps
Line Cord: 6 ft., captive, 14 AWG, with 3-conductor Edison plug
Lamps: Two 120V incandescent bulbs, 4 watts each
Operating Voltage: 120VAC 60Hz
Spike Protection Mode: Line to neutral
Energy Dissipation: 170 joules
Peak Impulse Current: 12,000 amps
Maximum Continuous Opterating Voltage: 130 VAC RMS
Let Through Voltage (@ 125 amps, 8/20uS waveform) 400 volts
Noise Attenuation: Transverse mode: Greater than 26dB, 200Khz to 10 Mhz
Dimensions: 1.75” H x 19” W x 7.5” D
Weight: 5.8 lbs.
Warranty: Merit Series units are protected by a limited three year warranty covering defects in materials and workmanship.