Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic

Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic
Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic
Item# Shure-PGXD14-BETA98H
$549.00
Availability: Usually ships the next business day

Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic

Free Ground Shipping

* PGXD1 transmitter with WA302 Instrument Cable

* Rugged, compact bodypack with belt clip and instrument cable

* 20Hz 20kHz frequency range captures every nuance of your tone

* Power, mute, and battery status LED

* Up to 10 hours of continuous use from 2 AA batteries

* 200' (60m) operating range

* 26dB of continuously adjustable gain to match variable input levels

* PGXD4 Wireless Receiver

* 24-bit / 48kHz digital technology for incredibly accurate sound

* Automatic frequency selection locates a clear channel instantly

* One-touch sync automatically syncs the transmitter and receiver

* True digital diversity delivers rock-solid wireless signal reliability

* Up to 5 systems can be used at once

* 1⁄4" and XLR audio outputs

* Included padded carrying case for portability and protection

* Beta 98H/C

* 3m (10 ft.) high-flex cable with attached preamplifier (XLR connection)

* Tailored frequency response for open, natural sound reproduction

* Compact, lightweight construction provides a low degree of visibility

* Interchangeable microphone cartridges are available:

* RPM108 - Cardioid cartridge

* RPM110 - Supercardioid cartridge

Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic Specifications:

* PGXD1 transmitter/strong>

* Audio input level: +10 dBV maximum, at minimum gain setting -16 dBV maximum, at maximum gain

* Gain adjustment range: 26dB

* Input impedance: 1MΩ

* RF Output Level: 10 mW maximum (dependent on applicable country regulations)

* Dimensions (HxWxD): 108mm x 64mm x 19mm (4.25" x 2.50" x 0.75")

* Weight: 128g (4.5oz.) without batteries

* Housing: Molded polycarbonate case

* Power requirements:

* Battery Life: Up to 10 hours

* PGXD4 receiver

* Dimensions (HxWxD): 40mm x 181mm x 104mm (1.6" x 7.125" x 4.1")

* Weight: 289g (10.2oz.)

* Housing: ABS

* Audio Output Level (ref. 38kHz deviation, 1kHz tone): XLR connector (into 3000Ω load): -2.5dBV 1/4" connector (into 10000Ω load): +10 dBV

* Impedance:

* XLR: 50Ω

* 1/4": 50Ω

* Sensitivity: -102 dBm @ 10-5 BER

* Image rejection: > 70dB, typical

* XLR output:

* Impedance balanced Pin 1: Ground (cable shield)

* Pin 2: Audio

* Pin 3: No Audio

* Audio LED:

* Red: 2dB below clip

* Amber: 12dB below clip

* Green: 50dB below clip

* Power Requirements: 12-18 Vdc at 150 mA, supplied by external power supply

* Pin Assignments: XLR: 1 = ground, 2 = hot, 3 = cold 6.35mm (1/4") TRS: Tip = audio, Ring = no audio, Sleeve = ground

* Beta 98H/C

* Type: Condenser (electret bias)

* Frequency response: 20 to 20,000Hz

* Polar pattern: Unidirectional (cardioid)

* Output impedance: Rated at 150Ω (actual)

* Recommended minimum load impedance: 1 kΩ (May be used with loads as low as 150Ω with reduced clipping level

* Output Level (0 dB = 1 volt per Pascal):

* Open Circuit Voltage: -56dB (1.6mV)

* Output Clipping Level (at 1kHz, THD < 1%):

* 2.5kΩ load: 11dBV (3.5V)

* 1.0kΩ load: 3dBV (1.4 V)

* Maximum SPL:

* 2.5kΩ: 163dB

* 1.0kΩ load: 155dB

* Dynamic Range (maximum SPL to A-weighted noise level): 132dB (2.5kΩ load)

* Signal-to-noise ratio: 63dB at 94dB SPL (IEC 651)

* Polarity:

* Positive pressure on microphone diaphragm produces positive voltage on pin 2 relative to pin 3 of preamplifier output connector

* Recommended Operating Voltage: 11 to 52 Vdc Phantom

* Environmental conditions: Operating temperatures: -7 C to 49 C (20 F to 120 F)

* Storage temperatures: 29 C to +74 C (-20 F to 165 F) * Relative Humidity: 0 to 95%

* Net Weight: Microphone w/cable and preamplifier: 156g (5.5oz.)